[. . . ] Update 01/2004 The WING-HOLDER The Beiter Wing-Holder is designed to position and fletch vanes (e. g. [. . . ] - Pic. 4 Turn the Beiter Wing-Holder and position the tape along the edge of the vane. Than cut the useless parts of the tape on both sides with scissors or a knife. - Pic. 6 Hint: Prepare more vanes ready to be fletched on more Wing-Holders and keep them safe in your quiver or bowcase. HOW TO FLETCH THE VANE Strip off the second layer of the tape, so the fletching surface is free. Put the Beiter Wing-Holder on the arrow shaft, so that both pins are in contact with the shaft. Align the Beiter Wing-Holder along the drawn line, using the three positioning sectors placed along the vane edge. - Pic. 7 Note: Place the vane in the correct direction on the shaft, as shown on the Beiter Wing-Holder (Nock - Point) - Pic. 1 Pay attention to place the vane along the drawn line and not on it!Than release the pressure completely and turn away the shaft from the Beiter Wing-Holder. [. . . ] +49 7720 856860 Fax +49 7720 4238 email: info@wernerbeiter. com Werner Beiter Daimlerstr. [. . . ]